How to make an Ethernet cable without using a crimper?

Networks have become a useful tool to maintain communication, they are also widely used in the field of entertainment, as well as in aspects of work. In short, where networks are a very useful tool in this technological age, but how to make an Ethernet cable without using a crimper ? Find out here.

Ethernet cable

Ethernet cable is the most used cable in le world to establish network connections in the local area, this cable is also known as cable UTP (unshielded twisted pair). It is characterized by the fact that it is a cable with a braiding system which is mainly used for connection in communications.

It is a guarantee for the creation of local networks, connections between servers and many related aspects. A feature of this Ethernet cable is its color evaluation. He 8 different colors and their combination is used for various tasks.

The colors are: white with orange, orange, white and green, blue, white and blue, green, white with brown and finally brown. They are made without shielding, which means they do not have a built-in wire mesh or coating to protect the cable. Ce cable is very fragile, so be careful when handling it. 

Of course, that's not the only reason why there may be a connection failure in networks .

Commonly used tools to be able to crimp an Ethernet cable are: the crimping tool and the pliers. But if we don't have a crimper, we will show you how to make the ethernet cable without using a crimper .

Step by step to crimp without crimping

The crimping pliers is a tool known by different names, among the most common: a crimping or crimping pliers, a compression pliers and a crimping pliers. This tool is used to crimp or make sure that the parts do not move and adhere to each other.

In the case of a Ethernet cable , we can easily use this tool to join a connector with the cable. But if we don't have this tool, there is another way to do it.

To do this, we will need the Ethernet cable, two RJ-45 cable connectors, scissors, and a flat screwdriver. Now we go to step by step to be able to crimp the Ethernet cable and it is as follows:

1. You have to use the scissors very carefully and make a cut on le côté cable that allows us to extract or discover the value of colors.
2. Then we need to do the color combination from left to right as follows ( this is the "B" standard ): orange - white, orange, green - white, blue, blue - white, green, brown - white and brown.
3. Once the combination is done, cut the ends of the cables and place them in the RJ-45 connector. The connector must be with the tongue round down and then we are going to introduce the cable, we need to make sure that no color cable is left out of the connector.
4. With the screwdriver we will drive the cable through the official du connector forcefully to ensure that the connector does not come off the cable.
5. At the tip of the connector we will see some brooches golden , these pins must be in contact with the colored wiring and for this, using the flat screwdriver, we will press one by one.
6. Finally, it is necessary to check that the pins are well pressed and fixed.

Remember that this is a solution temporary , the best option is to crimp the cables with a crimper to ensure the durability of the connection. However, by following these steps, you will be able to enjoy a wired internet connection using a local area network.

It is important to note that depending on the type of network or use, a technical evaluation must be made, as appropriate for which type of Ethernet cable is most suitable.

In this article you find out how to make a thread by Ethernet without step of crimping. On top of that, you learned what color combination is and remember that if you liked this article, don't forget to share it and recommend this page. Find other related articles as well.